This page is not created by, affiliated with, or supported by Slack Technologies, Inc.
2020-01-01
Channels
- # adventofcode (1)
- # announcements (10)
- # babashka (13)
- # beginners (104)
- # braveandtrue (2)
- # calva (5)
- # clj-kondo (23)
- # cljdoc (8)
- # clojure (10)
- # clojure-finland (1)
- # clojure-greece (1)
- # clojure-norway (2)
- # clojure-sweden (7)
- # clojure-uk (29)
- # clojurescript (20)
- # community-development (12)
- # cursive (4)
- # datomic (1)
- # duct (2)
- # emacs (24)
- # fulcro (48)
- # off-topic (5)
- # pathom (2)
- # planck (2)
- # quil (3)
- # reagent (17)
- # reitit (7)
Hi all, happy new year! I'm getting some weird behaviour when using REPL in cursive, both local and remote. I cannot see any characters echoed as they are typed into the REPL pane. They still get sent across as I can blindly type (+ 1 2) and get 3 back. This may be more to do with IDEA than Cursive, but I'm not sure where to start. I'm on Win10, IDEA Community 2019.3 and Cursive 1.9.0-2019.3 individual license. Any ideas?
CLJ's own repl works just fine, but I need one with my classpath...
Hi Igor, happy new year to you too! That sounds very odd. Can you actually see the REPL input pane? There’s a thing which happens sometimes which is that the REPL input pane gets collapsed so much that it’s basically invisible. If that’s the case, hunt around a bit on the bottom of the output pane, and you’ll find a little handle there you can use to drag the input pane open.