Fork me on GitHub
#calva
<
2020-01-04
>
pez16:01:31

OT: Santa-wife brought me a Chinese cleaver. And sharpening tools. (The factory sharpening of most knives, even expensive ones, is quite rough). I thus replaced the factory edge with one that can do this. 😎

😮 3
🔪 2
otwieracz18:01:46

@pez say goodbye to your finegers and fingers of everyone you love

😎 1
pez22:01:33

It is probably safer with a sharp knife than with a blunt one. Or so they say. Last finger count was OK, anyway. 😃

dabrazhe21:01:48

Re printing in repl: after trying the settings "calva.prettyPrintingOptions" the repl stopped printing at all : )) The settings are below. Ideas ?

"calva.sendAsyncOutputTo": "REPL Window",
    "calva.prettyPrintingOptions": {
        "enabled": true,
        "printEngine": "pprint",
        "width": 100
    },

pez22:01:19

Hmmm, does it print with other pprint options?